Reply to thread

Message

Alrighty then!

For about 17 bucks, I have the supplies I need to modify my vac-former. I realized that I dont need to make a whole new extention cord, but that I can just replace the plugs. The wires themselves are already capable of carrying the charge, so it would be a waste to have buy a whole new length of it.

The peg board has like an aluminum coat over the top, which is smooth and will work well. I just need to go work on it now!

-tubachris

[QUOTE="tubachris85x, post: 103084, member: 1226"] Alrighty then! For about 17 bucks, I have the supplies I need to modify my vac-former. I realized that I dont need to make a whole new extention cord, but that I can just replace the plugs. The wires themselves are already capable of carrying the charge, so it would be a waste to have buy a whole new length of it. The peg board has like an aluminum coat over the top, which is smooth and will work well. I just need to go work on it now! -tubachris [/QUOTE]

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification