Reply to thread

Message

It went very well, 3 hours long but it was a good night, thanks for asking!

I had actualy thought about possibly cutting the helmet mold in two, but Im afraid of how it would look having seam running down the center of it. Im just going to use thicker plastic, maybe even try to use ABS so that it will match the rest of the helmet pieces. Jus to throw out this question, does anyone know the type of ABS or even what source they use for the FX TK suits? Thanks guys!

-tubachris

[QUOTE="tubachris85x, post: 103002, member: 1226"] It went very well, 3 hours long but it was a good night, thanks for asking! I had actualy thought about possibly cutting the helmet mold in two, but Im afraid of how it would look having seam running down the center of it. Im just going to use thicker plastic, maybe even try to use ABS so that it will match the rest of the helmet pieces. Jus to throw out this question, does anyone know the type of ABS or even what source they use for the FX TK suits? Thanks guys! -tubachris [/QUOTE]

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification