Reply to thread

Not sure if you know about this site already, but http://www.studiocreations.com/howto/index.html has a lot of great tips on how to go about this under their "vaccuforming basics" thread. They seem to use a combination of a heat gun and an oven.


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top