Reply to thread

Thanks guys

 

I will be starting on the shoulder armor this week. I think this piece may be a bit difficult because the outer lip is more rounded off and already know is gonna be a pain in the butt. Im also working on getting an oven or several heating elements from waffle irons so that I can finish the vacu-former and not have to worry about it, and because I want to start practicing the casting and so I can cast the helmet piece and finish the helmet. Also, I was wondering if anyone could measure the areators on their FX, to see how far they stick out from the helmet. I have bought areators, but I need to know how far they should be poking outwards from the faceplate.

 

-tubachris


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top