Reply to thread

Message

You could probably do it with a jigsaw but you'd have to take it easy when you got to the corners. If you do use a jigsaw, I think it would be easiest drill a hole near opposite corners then just cut the sides straight to the un-drilled corners and finish the corner that you drilled with a file. I'll post a pic of what I mean when I get home.

Here is the idea.

[ATTACH=full]7022[/ATTACH]

[QUOTE="tbone9600, post: 102813, member: 1115"] You could probably do it with a jigsaw but you'd have to take it easy when you got to the corners. If you do use a jigsaw, I think it would be easiest drill a hole near opposite corners then just cut the sides straight to the un-drilled corners and finish the corner that you drilled with a file. I'll post a pic of what I mean when I get home. Here is the idea. [ATTACH=full]7022[/ATTACH] [/QUOTE]

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification