Reply to thread

Hey, I actually have something to show. Not very much, only did about an hour of sanding. I was working the forward, rounded part, that will be matching with the face piec. Almost got it to where it needs to be.

 

[ATTACH=full]81897[/ATTACH]

 

[ATTACH=full]81898[/ATTACH]

 

[ATTACH=full]81899[/ATTACH]

 

-tubachris


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top