Reply to thread

I went down, and got some power tools for making the molds. I acquaired a hand powered circular saw, a jigg saw, belt sander, and a hand planer. I still need to get one of those smaller hand sanders though. I can start making the molds this week once I get the MDF sheets from home depot. One major step closer to getting this completed!!!

 

-tubachris


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top