Reply to thread

Ok getting ready to do the knife sheves for the throwing blades, I will do 2 methods, on is applying a thin coat of sliver over the handles while  just using something like rub n buff on the blades, or just rub n buff the whole things. These are the blades I will be using


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top