Reply to thread

Having mastered the kit that Cruzer offers, I can give some advice.  From the pics I have seen, it appears Darkside kits come with a couple of small fiberglass tabs.  These are what you use to glue on the sides.  Thick cyanoacrylate glue & the fast set kicker are what I used to assemble mine.  You could also bend & glue in an aluminum strip if you are worried about flexing & stressing that area.  The darts I glued in with epoxy & used clamps until the adhesive set. I'll see if I can find my thread where I assembled my kit.


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top