I decided to tackle the attachment for the gauntlets first because frankly it was the most intimidating for me. I did tons of research and decided to follow the technique that Builder shared (pictured below) Gauntlet attachment methods
[ATTACH=full]226117[/ATTACH]
The gauntlets I received were basically just two halves with no connection built in.
First, I prepped the areas by sanding with a course grit to really scuff up the magnet/epoxy contact points. Next, I lined up my magnets and separated them with a playing card - this helped to make sure that the magnets were exactly aligned with the closure gap, because the playing card slightly slides into the gap.
Next I epoxied one side, let it set for about 30 minutes, removed the playing cards, and let it cure over night. I repeated this process for the other side as well.
Both gauntlets are done, and I’m happy to report that they clamshell shut PERFECTLY.
These are the magnets I went with: 3/4 x 1/4 x 1/4 Inch Neodymium Rare Earth Bar Magnets N42 (18 Pack)
Next, I’ll be adding the hinge straps.
[ATTACH=full]226119[/ATTACH]
[ATTACH=full]226120[/ATTACH]
[ATTACH=full]226121[/ATTACH]
