Reply to thread

What I have been doing is using my dremel with the sanding drum and sanding a dent into it. Then I coat the inside of the dent with spot putty, let it dry, then sand out the dent by hand to make it smooth. I've been real happy with the results


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top