Reply to thread

Kibosh,


 

Prymer13 is pretty much right on. I used a regular cheep mask when boiling Sintra and had a sore throat afterwards.....invest in a good respirator. As for cutting, I cut out my armor from 1/4 inch Sintra using a Jigsaw. It worked well because it was fast and it didn't melt anything. I cut it all outside! I used a file and sand paper afterwards to clean up the cut, again, outside. Turned out pretty nice. The thing about the fumes is that you can't see or smell anything. I usually eneded up with a soar throat like I mentioned (Before I read that it was dangerous). It's not worth taking the risk. Work with it outside and buy a good quality mask. Sometimes the masks will say on them what type of particles they will filter, mine had a valve on the front.

J-ROCK


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top