Reply to thread

This may sound like a stupid question from someone who's been around these boards for so long but I have a question regarding cutting a fiberglass helmet.  I've got my MSH2 sitting on the shelf staring at me in the exact same condition it came to me about 2 months ago.  I'm petrified of ruining it so I haven't cut out the T-visor yet.  I've never worked with fiberglass helmets before so I'm asking what I should do to cut out the visor area.  Should I use a dremel tool and just cut it out or should I use something else?


The tight corners towards the ends of the squint worry me with a dremel.  What would get into those spaces without ruining it?  Any sound advice would be very appreciated.


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top