Reply to thread

Greebles, clips, straps, hoses etc.





Now its time to start on the helmet.


So I went to our local gun show and got an awesome military grade gas mask for $20 and a couple of really cheap toy plastic army helmets.  I cut 1/3 off each helmet and then spliced them together.







I changed the color of the eye pieces to blue by cutting a piece of blue plastic notebook binder separator sheet and just sliding it behind the lense.  it works but makes seeing a little foggy...gonna have to figure a better method out...or i might just keep them clear and get some El wire and make them glow from inside the helmet.  I'll get back to that later....


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top