Reply to thread

if you're on a budget, and can't afford to buy premade armor, you could always print out the Wizard of Flight armor templates and cut the armor out of a sterlite trashcan.  You can shape the more intridate pieces by putting the sterlite in the oven for a few minutes and then bending it the shape you want,

my 2 cents worth


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top