Reply to thread

Message

Well, this is my custom mando that I've been working on.

[ATTACH=full]102080[/ATTACH]

[ATTACH=full]102082[/ATTACH]

[ATTACH=full]102085[/ATTACH]

It's not quite finished yet. I'm missing a holster, some plates for my sides (since I cut them off the backplate), and a few other odd and ends. Overall, it has the right look (I think), but is just missing some of the final touches. I hope to have it complete (or, as complete as armour ever is) in time for Pheonix CC '09.

A'den

[QUOTE="Aden Kyramud, post: 224065, member: 2827"] Well, this is my custom mando that I've been working on. [ATTACH=full]102080[/ATTACH] [ATTACH=full]102082[/ATTACH] [ATTACH=full]102085[/ATTACH] It's not quite finished yet. I'm missing a holster, some plates for my sides (since I cut them off the backplate), and a few other odd and ends. Overall, it has the right look (I think), but is just missing some of the final touches. I hope to have it complete (or, as complete as armour ever is) in time for Pheonix CC '09. A'den [/QUOTE]

This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification