Reply to thread

Hey guys. Been a while since i've been on here. but i'm about to start on a new project that i think you guys will like. i just recently Bought a 3d printer, and i've been working on a custom Boba Fett helmet. (Extremely loosely based from Rafalfett's Boba fett 3d model, not much remains of the original model however, but thank you raf!) so, while it's not printed yet, i have some teasers.


Overlayed over a scan of an original helmet (image released by Hasbro):

[ATTACH=full]219686[/ATTACH]


And my model next to Said scan Pic:

[ATTACH=full]219687[/ATTACH]


Dramatically lit pictures:

[ATTACH=full]219695[/ATTACH][ATTACH=full]219694[/ATTACH][ATTACH=full]219693[/ATTACH][ATTACH=full]219692[/ATTACH][ATTACH=full]219691[/ATTACH][ATTACH=full]219690[/ATTACH][ATTACH=full]219689[/ATTACH][ATTACH=full]219688[/ATTACH]



And one more realistically lit picture:

[ATTACH=full]219696[/ATTACH]


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top