Reply to thread

Since the shin and boot armors are at points I'm satisfied with, I decided to now drag my thigh armor project out of the unfinished projects bin (f.y.i. the unfinished Seeker cod project is next;)). Here is the right thigh. I'll be finishing up the left one this week and getting them ready for molding. I still need to adjust the curvature from side to side just a tad. They will be approximately 11.25" tall along the curvature on the center line, and about 9" wide along the curvature on the center line.:thumbsup:


[ATTACH=full]12733[/ATTACH]


[ATTACH=full]12734[/ATTACH]


[ATTACH=full]12735[/ATTACH]


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top