Reply to thread

ahahah...ok, I'll put that combo away for future use.:lol:

I'll be molding the shin and boot armors this weekend if I'm at the shop again.

 

As for the knees, I'm undecided about what width would be best: 4.75", 5", or more? Once I know what width to go, the rest will fall into place. Oh, and we have decided to do molds for both fiberglass and Hyper-Firm rubber for the knees.

 

thanks


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top