Reply to thread

Not sure about threaded posts? The brad tee nuts are threaded, then you need screws of the proper diameter to thread into them, along with the visor and required washers. I've been thru several visors trying to find one I like. Just ordered one from cyberweld. A shade 5 visor, .060 thick and precurved. Had a green one at .040 thick I had cut out, and was ok? with the green, but then I got superglue on it and ruined it. Will now serve as a template for the new one though.


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top