Reply to thread

Have you tried the visors at T-visor.com? They look really nice and are formed. 3mm thick. Think they were $12 each....I got one but haven't fit it to my helmet yet.


I hear you with epoxies though. Many do not hold up well to shear loads of any kind, but if you let it(JB Weld) sit 24 hrs and it was prepped right, you'd have to use like King Kong pressure to pull them off!


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top