Reply to thread

Gotta make sure the area is free of any contaminants, and the adhesive has to be allowed to cure. Some CA glues take quite some time to reach full cure if the volume is past a drop.

I'd recommend JB weld as long as it's used sparingly. Been holding down rare earth magnets on my gauntlets for months.


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top