Reply to thread

There are some great idea here, thanks!


Have any of you tried to fiberglass in an RTV mold?  I would think that the RTV would be more forgiving to the original plug.  It has been suggested to me to put a thin layer of RTV over the plug and then create a 2 part plaster mold for support.  This sounds like a great idea and was wanting to find out if anyone has ever made a mold with this method.


This thread is more than 23 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top