Reply to thread

I printed the main part of the jet pack in 4 pieces and each piece is decently heavy. I’d hate for them to come apart from the weight while wearing it. How are you connecting your printed pieces together? I feel like superglue would be too simple of an answer for something like this


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top