Reply to thread

Message

It looks like the masking tape used for the killstripes pulled off some paint off the dome, and they fixed it painting over it with the same green as used on the dome.

ESB:
[ATTACH=full]202803[/ATTACH]

PP3
[ATTACH=full]202804[/ATTACH]

So you could either mimick that on your helmet by scratching away some paint to reveal the silver layer, or paint a “tape pull” with silver and then paint over that with your dome green, thinned down to be translucent. That’s what I did and I’m quite pleased with it.

[QUOTE="Jango Fett Jr, post: 506155, member: 102"] It looks like the masking tape used for the killstripes pulled off some paint off the dome, and they fixed it painting over it with the same green as used on the dome. ESB: [ATTACH type="full" alt="CDCE8BC7-7D74-4A49-A1C2-0461CA01A66C.jpeg"]202803[/ATTACH] PP3 [ATTACH type="full" alt="BDA607DA-95B4-4B66-9A7E-F06BA2C6D908.jpeg"]202804[/ATTACH] So you could either mimick that on your helmet by scratching away some paint to reveal the silver layer, or paint a “tape pull” with silver and then paint over that with your dome green, thinned down to be translucent. That’s what I did and I’m quite pleased with it. [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification