Reply to thread

Let me get out my calipers...  ;)


OK...


The BASE measures 15mm on each side


The TOP measures 10mm on each side


The HEIGHT is 11mm



Keep in mind that I have NO idea how close these are to the "real deal".  I made these in a proportion that *I* liked, AND in a size that fit *my* shoulder armor.  :)


Hope it helps!  :D


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top