Reply to thread

As per our discussion privately, I figured I'd post the conclusion :lol:


Urethane resin was the issue. Smoothcast 325, and metal powder = so - so results, at best.


Polyester Layup-Resin, clear is the best if anyone is following this thread for tips :)


FP


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top