Reply to thread

I am making a cold cast removable board for my TF... using Sipdys little invintion as a jump off point... but sadly it just looks like Titanium metal. :( But I did not use "layup resin" nor did I use enough metal powser from what TF tells me.



This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top