Reply to thread

So I’m starting on a Jango Fett helmet and upper torso armor build. I 3D printed all the parts and cleaned them up and in the process of molding the armor to cold cast. I’ve already finished the helmet and cast a couple with the third one coming out perfect for painting. I’ll post updates as I go along. The rangefinder and stem and ear cap pieces I cast separately.

[ATTACH=full]208220[/ATTACH][ATTACH=full]208221[/ATTACH][ATTACH=full]208222[/ATTACH][ATTACH=full]208223[/ATTACH][ATTACH=full]208224[/ATTACH]


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top