Reply to thread

hi everyone, im working on the bmx potty + filler helmet, in the photo below youll see my custom cold cast alu stalk(hollow). My question is , whats the best way to eliminate bubbles in the resin? Any pointers would save me making hundreds of these "swiss cheese stalks" before i finally get it right, all ideas greatfully received:)  Cheers TF


[ATTACH=full]4243[/ATTACH]


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top