Reply to thread

Just general info Russ, I was just looking at basic prices, in case I do something in the future. Also, when doing it by hand, do you just have it spin and then shape it with tools??? kind of like a potters wheel???


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top