Reply to thread

Just to get an idea, I got a quote to have these made from a normal machine shop, this is same material and no anodizing.


Most importantly, this is for one of the 6 parts that make up the set.


[ATTACH=full]192280[/ATTACH]


I will be significantly cheaper than this.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top