Reply to thread

Setup everything for the second op and and got them cut.  Turns out I made them a little to large and they wont tighten down on the flash tube.  I've reworked the model and can make some new ones that will fit correctly.


Here's some pics of the slightly too large ones:


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top