Reply to thread

Thanks guys. Ok, the pistol is done. I wanted to finish it first because I needed it to figure out the thigh armor and holsters. I'm only making the one and will mold it later for solid resin casts. I took the liberty of adding a trigger because it just didn't look right without one. With the aluminum barrel tip it's about 9.5" long, which works well with the size of the BKBT thighs. :thumbsup:


Thanks


[ATTACH=full]114863[/ATTACH]


[ATTACH=full]114864[/ATTACH]


[ATTACH=full]114865[/ATTACH]


[ATTACH=full]114866[/ATTACH]


[ATTACH=full]114867[/ATTACH]


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top