Reply to thread

While I would agree with clone six for those who troop a lot, would it not be possible to create an undersuit that was thin in the hidden areas and ribber in the areas that are obviously seen, or is the armor too open for this and you would be forced to go all ribbed?  Is there anything we could do to simulate the ribbing without going for full-blown, padded, non-breathable sweatsuits?


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top