Reply to thread

Quick preventative question. Using 2mm clear acrylic, heating it up with a heat gun to bend it into a visor shape, will I distort the transparency or cause it to buckle, crumple or distort in any way? I don't mean the shape, but the view through it, if that makes sense.


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top