Reply to thread

Sizing wise they look to be on the right track. I'd clean up the edges with some needle files to make all the edges straight and square and that will open them up the last little bit they should be. Don't forget you'll also need some red film to put in front of the display (something I'm working on to include in future kits).


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top