Reply to thread

Message

If you're going to rivet your armor onto your vest (which I wouldn't recommend) you wouldn't be able to access the back of the chest lights to install the battery. You'd have to cut a window into the vest behind the chest plate.

Don't rivet on the armor, either use heavy duty snaps or velcro OR you can epoxy flat-head screws onto the back of the armor, push them through small holes you cut into the vest and screw on a nut on the inside of the vest.

[QUOTE="webchief, post: 55795, member: 26"] If you're going to rivet your armor onto your vest (which I wouldn't recommend) you wouldn't be able to access the back of the chest lights to install the battery. You'd have to cut a window into the vest behind the chest plate. Don't rivet on the armor, either use heavy duty snaps or velcro OR you can epoxy flat-head screws onto the back of the armor, push them through small holes you cut into the vest and screw on a nut on the inside of the vest. [/QUOTE]

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification