Reply to thread

Thanks Jeff.  It helps a lot that all you guys know the real specific and resources on this stuff.  I've been grinding away at the circuit board design and just today said "uncle" on trying to get it to fit on a 3" x 4".  It's looking more like a 3.5" x 4.5".  But hey, only partial defeat right?  I'm sure that we can get that later sequence going but the board size may make it less likely to be something you'd want to keep on one board.  It'll be designed with either option in mind though.


Rafalfett, those measurements will workout perfectly.  Thanks for posting.


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top