Reply to thread

Seeker,

I just finished sanding, weathering, and re-sanding my aluminum chest, shoulder, and cod Armor.  I made my own aluminum thigh, shin, toe and knee armor.  I still gotta make some knee obxes out of aluminum stock and re-do my Deano knee darts...It isn't screen accurate, but it's lookin' mighty fine :)  I gotta get some pics up after I get back form Ft. Lauderdale...going there over the 4th :) :) :) Yippie! :lol:


Neil


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top