Reply to thread

Can someone point me to measurements for the size/position of the slits in the chest plate and the right size LEDs to use?  For now I plan on just leaving a piece of dark plexi behind the slits but eventually I'd like to try and get some real working LEDs going.  I could swear I saw the dimensions posted somewhere before but I can't find it now...thanks!


Mark


This thread is more than 23 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top