Reply to thread

Yeah, it's an RoTJ one right now. The translucent piece doesn't sit straight on the ESB version. It's quite crooked. I'll probably finish the range finder last. I have to get the other piece done on it and then position it along with the translucent segment as the finishing touch.

 

This is done in Lightwave 7.0

 

 


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top