Reply to thread

Hi there everyone,


As perhaps some of you know, I have a scratch build Fett helmet in progress, and I've only just now come to the point of wondering how the ear detail pieces had best be reproduced, since I had never really seen what the typical process was for those. Since I imagined they would be casted, I was wondering if anyone had any insight to share on that topic, as to the simplest way to get the most detail, especially as regards areas such as the hole areas in the top of the bottom right ear, the deep groove in the left ear, and especially the reproduction of a hollow piece like the rangefinder cap (I'm just calling it that, the big black piece for those who are confused). Thanks very much for any input you might have!


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top