Reply to thread

So I've been doing quite a bit of casting recently but I've been having issues getting a good rigid cast of my rangefinder stalks.  Eventually I've been embedding a piece of aluminum in the resin as I'm casting but I was wondering if anyone else has a different method for making the stalks so they come out rigid instead of having a pliable consistency.  I've been casting them in Smooth-On 320 and I've even tried 65 D but nothing seems to work as well as I'd like.


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top