Reply to thread

Hey there,


I just wanted to know if anyone has the low-down

on most of the popular casting/molding materials out

there? I keep seeing things posted about non-fiberglass

resins, fiberglass, etc. Can someone tell me about the

pros and cons of working with these materials; what

the finished products of these materials come out like;

and what ARE the most commonly used materials for

casting/molding? Any help would be greatly appreciated.

Thanks!


BTW- I'm not trying to recast anyones work...just looking

into sculpting/casting  my own stuff.  :)


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top