Reply to thread

My point is that not all keyslot sections are the same size across different helmet casts so if the MQ1 piece is a real found part you'll need to be consistent in terms of the helmet you're trying to replicate so far as the cast you're using allows you to; you might line it up on one side but not the other.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top