Reply to thread

Still on planning stage of my Llats but working on my other MMCC kit. Using a mix of Sintra and 3D print the armor is coming along ready for paint


[ATTACH=full]146217[/ATTACH]


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top