Reply to thread

Message

Hot glue or epoxy the biceps to the shoulder bells. This is done to keep the shoulder bell from siding under the biceps while trooping.
[ATTACH=full]121790[/ATTACH]
Once finished your pieces should look something like the photos below.
[ATTACH=full]121791[/ATTACH]
[ATTACH=full]121792[/ATTACH]

[QUOTE="DW Design, post: 320994, member: 258"] Hot glue or epoxy the biceps to the shoulder bells. This is done to keep the shoulder bell from siding under the biceps while trooping. [ATTACH=full]121790[/ATTACH] Once finished your pieces should look something like the photos below. [ATTACH=full]121791[/ATTACH] [ATTACH=full]121792[/ATTACH] [/QUOTE]

This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification