Reply to thread

All of the vaced pieces should be build, primered and painted white.

We will move onto building the strapping system and other stuff that goes along with these pieces.

Most of the items below can be purchased at Wal Mart. A complete list is in the PDF tutorial that was

included with the kit. The foam rubber used for padding is always the toughest item to find.

I get mine from Orchard Supply Hardware. It comes on a roll and they can trim it to the size needed.

I get the 3/8” thick stuff and get it trimmed to 24” x 18”.

[ATTACH=full]121602[/ATTACH]

Cut out the templates included with the tutorial and trim foam as needed. Save the extra scrap pieces,

they can be used later. I like to add them to the forarms as well as other pieces.

[ATTACH=full]121603[/ATTACH]

[ATTACH=full]121604[/ATTACH]

Use the white plastic included in the kit and make four squares per attached photo.

These will be glued to the shoulder bells and thigh’s.

[ATTACH=full]121605[/ATTACH]


This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top