Reply to thread

Message

I emailed the guy about his vac table, awaiting a response. Although I like the compact design of the flip-top version, I'm concerned about the plastic sagging to one side of the frame as the frame is pulled across:

[ATTACH=full]80954[/ATTACH]

I'm guessing that the sag would cause a curved wrinkle over the mold area. Has anyone else built a setup like this? Did you have any issues?

I should be finishing up my table-top version this weekend, and will post pics once I fill some mold masters.

[QUOTE="batninja, post: 45032, member: 229"] I emailed the guy about his vac table, awaiting a response. Although I like the compact design of the flip-top version, I'm concerned about the plastic sagging to one side of the frame as the frame is pulled across: [ATTACH=full]80954[/ATTACH] I'm guessing that the sag would cause a curved wrinkle over the mold area. Has anyone else built a setup like this? Did you have any issues? I should be finishing up my table-top version this weekend, and will post pics once I fill some mold masters. [/QUOTE]

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification